Set port duplex command – Motorola CAJUN P120 User Manual
Page 107
Chapter 7
Cajun Campus CLI (Command Line Interface)
Cajun P120 User’s Guide
93
Examples:
To configure port 2 on module 1 port speed to 10 Mbps:
Console>(enable) set port speed 1/2 10
Console>(enable)
Set Port Duplex Command
Use the
set port duplex
command to configure the duplex type of an Ethernet
or Fast Ethernet port or range of ports.
You can configure Ethernet and Fast Ethernet interfaces to either full duplex or half
duplex. The duplex status of a port in negotiation mode is determined by
negotiation. An error message is generated if you attempt to set the transmission
type of negotiation Fast Ethernet ports to half or full duplex mode.
The syntax for this command is:
set port duplex [slot_num/port_num]{fdx|hdx}
Example:
To set port 1 on module 1 to full duplex:
Console>(enable) set port duplex 1/1 fdx
Port 1/1 set to full-duplex.
Console>(enable)
slot_num
Module number (always 1)
port_num
Number of the port on the module
fdx
Keyword to specify full-duplex transmission
hdx
Keyword to specify half-duplex transmission