beautypg.com

Ip-multicast system group (ip-multicast), Table 6.8, Ip-multicast group parameters – Motorola CAJUN P120 User Manual

Page 69

background image

Chapter 6

Legacy CLI (Command Line Interface)

Cajun P120 User’s Guide

55

IP-Multicast System Group (IP-MULTICAST)

This group provides the IP Multicast configuration according to IGMP standards.
The table below displays the parameters, a description of the parameters, the
default values, and the valid range of values.

To view or change these parameters, type the command:

set|show IP-multicast list

BOOTP-MODE

There are three settings for the Bootp-mode command:
• once – Attempts to configure parameters from the Bootp

client server when the Cajun P120 is powered on. Once
Bootp is successful, then the setting is automatically changed
to ‘never’.

• always – Attempts to configure parameters from the Bootp

server each time that the Cajun P120 is powered on.

• never – Does not attempt Bootp
See also ”Configuring Cajun P120 IP Address with Bootp” in the
Installation and Setup chapter.
We recommend that you set the bootp-mode to “never” if you will not be
using a Bootp server. If you change this setting, it will not take affect
until the switch is reset or powered off and on.

SLIPIP

Enter the IP address and net mask for the SLIP connection. The
IP addresses for the Cajun P120 and management station must be on the
same subnet.

SLIP-PEER-IP

Enter the IP address for the management station with the SLIP
connection.

Table 6.8

IP-multicast Group Parameters

Parameter

Description

Default
Value(s)

Valid Range
for Values

IPMC-
FILTERING

Enables/Disables IP-multicast
mode

Disabled

Enabled/
Disabled

IPMC-HOST-
AGING

Time after which a host who
has stopped sending IGMP
reports is removed from a
Multicast Group

10 Minutes

30 Seconds to
30 Minutes

IPMC-ROUTER-
AGING

Time after which the router
port information is deleted
when the router is inactive

30 Minutes

30 Seconds to
2 Hours