Privileged level commands, Table 6.2 – Motorola CAJUN P120 User Manual
Page 55
Chapter 6
Legacy CLI (Command Line Interface)
Cajun P120 User’s Guide
41
Privileged Level Commands
You must enter the Privileged level, with the
login
or
flogin
command, before
accessing these commands. These commands are available in addition to all the
Normal level commands, except for the
simple-setup
command.
Table 6.2
Privileged Level Commands
Command Syntax
Function
cam-find
Lookup for specific MAC address in the
soft-CAM
exit
Saves and exits the Privileged level (not the
session) and returns to the Normal level
factory-def
Reset parameter values to their factory defaults
genstat
Displays general traffic statistics for the
Cajun P120
prompt
Changes the CajunP120 prompt to the text that
you specify. The new prompt only takes effect after
performing the write command.
reload
Rereads the last saved configuration settings
reset
Resets the Cajun P120. This is equivalent to
powering the switch off and on again.
rmonreset
Sets the Rmon MIB factory values.
set
Example: set ip list
Set parameter values for a specific group
setmib
Sets a MIB value
setpw
Changes the Privileged level password
sh-swt-stat
Displays received statistics for the port that you
specified
stopr
Disables the repetitive command level
(option [r])
tftp-cmd [start|stop|status]
If you use the tftp-cmd stop
command, after resetting the
Cajun P120, it will boot up from
its INIT software.
Starts, stops or displays the status of the TFTP
process.
TFTP will not start if TFTP-OP is set to notftp in the
TFTP group.
write
Saves the current configuration in the Cajun
P120’s flash memory