beautypg.com

Running the cli, Easily configuring the mandatory parameters, Using the simple-setup command – Motorola CAJUN P120 User Manual

Page 46

background image

Chapter 6

Legacy CLI (Command Line Interface)

32

Cajun P120 User’s Guide

Running the CLI

After running Telnet or connecting to the Console port, press Enter until the CLI
begins and the

CajunP120>

prompt displays.

You are now in the Normal security level. Now you either need to use the simple-
setup command as described below to easily configure the mandatory parameters,
or enter the Privileged level. See the ”Entering the Privileged Level” section.

Factory default values, or the current defaults if the system was previously
configured, are provided in square brackets after each parameter. You may use the
default settings for any parameters that you desire. Although there are settings,
such as IP addresses, that require you to enter a parameter value.

Note: Refer to the section “Command Syntax” on Page 38 for general information
on the CLI user interface.

Easily Configuring the Mandatory Parameters

Using the Simple-Setup Command

The simple-setup command provides an easy way to configure the mandatory
parameters on the Cajun P120.

To use the simple-setup command:

1

From the

CajunP120>

prompt, enter

simple-setup

on the command line:

CajunP120>

simple-setup

.

2

Enter the password at the prompt to enter the Privileged level. The default
password is

enable

(lower case, without quotation marks).

>Enter password:

enable

The prompt changes to

setup>

to indicate that you are in the simple-setup

command.

The group name, a short description of the group, the first parameter and its
current value display are shown below:

Group: ip - Management IP parameter setup.

You are now going to configure the IP group. The first parameter is the Cajun P120
IP address. Its default setting is

149.49.32.134 255.255.255.0

.

setup> mng-port-ip [149.49.32.134 255.255.255.0]?

You may now set the Cajun P120’s IP address. Either:

Keep the default setting by pressing Enter, or

Type a new value and press Enter. For example, to change the IP address,
enter:

194.90.121.114 255.255.255.0