beautypg.com

Index_value subcommand

Page 58

background image

Chapter 6

Legacy CLI (Command Line Interface)

44

Cajun P120 User’s Guide

With the

set

command, the system will wait for you to either press Enter to keep

the current value for the parameter, or enter a new value for the parameter.

The next parameter in the group will display and it will wait for your action. It
continues through every parameter in the group one-by-one.

Note: It is recommended to use the

list

subcommand until you are very familiar

with the CLI parameters.

Use the

list

subcommand in this format:

list

The following example allows you to set parameters in the IP group one-by-one:

CajunP120-priv# set ip list

The following example will display all the current parameter settings one-by-one:

CajunP120-priv#

show all list

Index_value Subcommand

When an index value is used on the command line, enter the desired port number
to be configured.

To configure a specific port with several parameter values, enter commands in the
format:

The following example allows you to configure parameters in the P120 group for
port 4:

CajunP120-priv# set P120 4 list

The parameters display one-by-one.

Depending upon the command, you may sometimes use

all

for the index value.

Repetitive Command Mode [r]

When the repetitive mode command is used on the command line, the command is
automatically repeated every few seconds. This is a good way to see what happens
as you make system modifications.

The following example will repeatedly show the statistics for switched port #2:

CajunP120-priv# sh-swt-stat 2 r

To cancel the repetitive mode, enter

stopr

on the command line.

CajunP120-priv#

stopr