Set port enable command, Set port disable command, Set port speed command – Motorola CAJUN P120 User Manual
Page 106
Chapter 7
Cajun Campus CLI (Command Line Interface)
92
Cajun P120 User’s Guide
Set Port Enable Command
Use the
set port enable
command to enable a port or a range of ports.
The syntax for this command is:
set port enable [slot_num/port_num]
Example:
To enable port 3 on module 1:
Console>(enable) set port enable 1/3
Console>(enable)
Set Port Disable Command
Use the
set port disable
command to disable a port or a range of ports.
The syntax for this command is:
set port disable [slot_num/port_num]
Example:
Console>(enable) set port disable 1/10
Console>(enable)
Set Port Speed Command
Use the
set port speed
command to configure the speed of a port or range of
ports. You can configure the speed of a Ethernet of Fast Ethernet interface only.
You can configure Ethernet or Fast Ethernet interfaces on the Cajun P120 module
to either 10 Mbps or 100 Mbps. In negotiation mode, the port's speed is determined
by negotiation. An error message is generated if you attempt to set the speed type
to 10 or 100 when negotiation is enabled.
The syntax for this command is:
set port speed [slot_num/port_num][10|100]
slot_num
Module number (always 1)
port_num
Number of the port.
slot_num
Module number (always 1)
port_num
Number of the port.
slot_num
Module number (always 1)
port_num
Number of the port on the module
10|100
Set a port speed to 10Mbps, 100 Mbps