Motorola CAJUN P120 - Manual (Page 100)

Chapter 7 Cajun Campus CLI (Command Line Interface)
86 Cajun P120 User’s Guide
Set Commands
Set Logout Command
The set logout command is used to set the number of minutes until the system
automatically disconnects an idle session.
The syntax for this command is: set logout
Examples:
To set the number of minutes until the system disconnects an idle session
automatically:
Console>(enable) set timeout 20
Sessions will be automatically logged out after 20 minutes of
idle time.
Console>(enable)
To disable the automatic disconnection of idle sessions:
Console>(enable) set timeout 0
Sessions will not be automatically logged out.
Console>(enable)
Set Port Mirror Command
Use the set port mirror command to define a port mirroring source-
destination pair in the module. the syntax for this command is:
set port mirror source-port mod_num/port_num mirror-port
mod_num/port_num sampling {always | disable } [direction both]
Number of minutes (0 to 10,000) until the system
automatically disconnects an idle session. Setting the value to 0
disables the automatic disconnection of idle sessions
Default = 20
mod_num Number of the source or destination module.
port_num Number of the source or destination port.
always keyword to activate this copy port entry.
disable keyword to pass this copy port entry to the "not ready" state.
both keyword to copy both incoming and outgoing traffic.