beautypg.com

Using the show command, Listing the groups you can set – Motorola CAJUN P120 User Manual

Page 59

background image

Chapter 6

Legacy CLI (Command Line Interface)

Cajun P120 User’s Guide

45

Using the SHOW Command

The

show

command is used to display the current settings for a particular group of

parameters. If you have never changed parameter settings, then these are the
factory default values.

The following example will display the current settings for the IP group:

CajunP120> show ip

Listing the Groups You Can Set

If you enter

set

on the command line, a list of the groups that can be set with this

command displays.

Note: This is useful for displaying the syntax for use in your configuration.

The available groups are:

CajunP120-priv#

set

Group list:

mibII-syst

MIB-II system group params

Cam

Cam parameters

ip

Management IP parameters setup.

IP-multi-

cast

IP-multicast parameters

STA-GEN

Parameters for configuring general spanning tree.

STA-PORT

Parameters for configuring spanning tree per port.

P120

Port configuration group

vlan

Vlan group

copy-port

Destination (network analyzer) and source ports setup

tftp

TFTP parameters setup.

snmp

Configuration of SNMP community names and trap
managers