FARGO electronic HDP600-LC CR100 - Manual (Page 90)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 3-44
Card Lamination Module Installation
Introduction
The following guide provides a step-by-step installation procedure for the HDP600
Lamination Module and Printer Driver Upgrade. Refer to the HDP600 High Definition Card
Printer/Encoder User Guide for details on operating your new card Lamination Module.
The time required for each installation is provided below:
• Lamination Module Installation (time required): This hardware installation process
will require approximately 10 to 15 minutes.
• Driver Software Installation (time required): This software installation process will
require approximately 2 to 6 minutes (depending on the speed of your PC).
The System Requirements are as follows:
• IBM-PC or compatible, Windows® 2K/XP, Pentium® class 133MHz computer with 64MB
of RAM or higher, 200MB free hard disk space or higher and USB 1.1