FARGO electronic HDP600-LC CR100 - Manual (Page 192)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 4-92
Resolving the Image Placement problems
Step Procedure
4 Verify if the Vertical Image Position Setting is set correctly or incorrectly.
See the graphic below.
• If the white border is on the top edge of the card, adjust the Vertical
value by +2.
• If the white border is on the botom edge of the card, adjust the
Vertical value by -2.
a. Click on OK.
b. Run a self-test.
c. If the white border is diminished, continue the adjustment until it is gone.