FARGO electronic HDP600-LC CR100 - Manual (Page 16)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 1-7
Reviewing the HDP600 Boot up Sequence
Step Process
Step Process
1 The Card feed stepper turns ON (to check for a card on the Flipper table).
2 The Hot Roller Lift turns until the head up position is returned from the Headlift
Sensor).
3 The Film transfer take-up Motor turns ON to take up any slack in the film.
4 The Print Headlift turns until head up position is returned from Headlift Sensor.
5 The Print Ribbon moves forward until it finds the yellow panel, pauses, advances
to magenta, then backs up to yellow (the Ribbon Sensor detects marks on the
ribbon).
6 The Transfer Film advances forward two panels from supply (advances until the
Transfer Film Sensor senses 2 marks on the Film).
7 The Transfer Film advances forward one panel from supply (advances until the
Transfer Film Sensor senses 1 mark on the Film).
8 The Transfer Film reverses for one panel onto supply (reverses until the Transfer
Film Sensor senses 1 mark on the Film).