FARGO electronic HDP600-LC CR100 - Manual (Page 351)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 8-8
Cleaning the Magnetic Encoder (continued)
Step Procedure
6 Press the REV button on the LCD display seven (7) times to feed the card
into the Magnetic Module. (Note: The card does not go all the way through
the Flipper Table.)
7 Hold the end of the Cleaning Card securely with your thumb and index finger
while you press the REV button on the LCD display five (5) more times.
(Note: This allows the Roller to spin against the Cleaning Card and fully
clean the Roller.) See below.
8 Remove the Cleaning Card by pressing the FORWARD button on the LCD
display to eject this card from the Printer.
9 The process is now complete. (Note: This magnetic cleaning process should
be done every time another cleaning is performed, which is roughly every
3,000 cards, or whenever you experience Magnetic Encoding problems.)
10 Be aware that the card can be used only once as it will dry out quickly.
(Note: If it dries out before you clean the Roller, a new card must be used.)