FARGO electronic HDP600-LC CR100 - Manual (Page 236)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 5-40
Changing the Root Password
The Passwords page allows the User to change the passwords needed to log in as a User.
Changes to all settings require a login. (Note: However, these changes are only protected
by password after the password has been set. Users can only be added or removed using
Telnet commands.)
Step Procedure
1 Select the Administration link.
2 Log in as a root User (using the old password) if you are so prompted.
(Note: Any change of setting will only be accepted after you have
successfully logged in.)
3 Select the Passwords link to get to the Password web page.
4 Enter the current password in the Root Password Old textbox or leave it
blank if no password has been previously set.
5 Enter the new password in the Root Password New textbox or leave it
blank if you want to remove the old password.
6 Re-enter the new password in the Root Password Confirm textbox or
leave it blank if you want to remove the old password.
Continued on the next page