FARGO electronic HDP600-LC CR100 - Manual (Page 103)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 4-3
Reviewing LCD Messages (continued)
Message Cause Solution
Card Jam: Lam There is a card jam in the
Laminator. Clear the jam.
Card Jam Error A card is jammed. Clear the jam.
Card Jam Flipper Error A card is jammed in the card
flipping area of the Printer. Clear the jam.
Multiple Card Feed
Error Two or more cards fed from the
Card Hopper. Remove the fed cards and
Verify the card thickness
setting is set to the
thickness of your cards.
Press RESUME to
continue.
Can’t Find Card Error The Printer was expecting to find a
card in the Printer but could not
locate it. If you have removed the
card, press CANCEL to
reset or REFEED to redo
the current operation with
a new card.
Press RESUME to look for
the card again.
Check Film Error The transfer film may be jammed,
not installed properly, broken or
damaged. Verify the film is installed
properly.
• If jammed, clear it.
• If broken, repair by
taping the Ribbon back
on to the take-up core.
Press RESUME to
continue or CANCEL to
reset the Printer. See
Resolving a Transfer Film
Mark Not Found Error
.
Continued on the next page