FARGO electronic HDP600-LC CR100 - Manual (Page 265)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 6-4
Opening the Card Lamination Module (continued)
Step Procedure
2 Open the Lamination Station by lifting up on the blue Securing Latches. Pull
the Lamination Station up and back into its fully upright position. Note the
Lamination Station is also designed to hold its last position to prevent it from
falling shut.
3 To close the Lamination Station, push the Lamination Station down until its
blue Securing Latches close securely.
(Note: The Lamination Station must be closed securely in order for your
Printer to operate. It is also recommended that the Top Cover be closed
whenever laminating for reliability and safety reasons.)