FARGO electronic HDP600-LC CR100 - Manual (Page 35)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 2-17
Printer Components: LCD and Softkey Control Pad (continued)
Component Description
Ready /
Printer Open
Screens Once the Printer has finished its system check and with the Printer
closed, the Printer will display READY to indicate that the Printer is
ready for operation. (Note: The Printer will stay in this mode until it
receives a print job or it is turned OFF.)
• If the Printer is opened, the Printer Open screen will appear. Press
either the FWD or BWD buttons to move the Printer's card path
Rollers in the indicated direction.
In any of these screens, the Printer will always display the Menu
option above the center softkey button.
Press this button to access the Printer's menu options. (Note: The
Menu option is available only in the Ready / Printer Open screens.)
• If the Printer is equipped with the Card Lamination Module and the
Lamination Station is opened, an LCD message will appear; and
the Lamination Module's LED will flash. (Note: To move the
Lamination Module's Rollers, push the Module's Cancel or
Resume buttons.)
• If both the Printer and Lamination Station are open, the LCD's FWD
or BWD softkey buttons will move ALL Rollers. In any of these
screens, the Printer will always display the MENU option above the
center softkey button. Press this button to access the Printer's
menu options. (Note: The MENU option is available only in the
READY / PRINTER OPEN screens.)