FARGO electronic HDP600-LC CR100 - Manual (Page 178)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 4-78
Resolving the Card Surface Debris problems
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
• Symptom: Prints have spots (white or colored voids) and/or dust on
them (See sample image below).
• Printer Error State: None
• LCD Error Display: None
• Driver Monitor Error Display: None
2 Ensure the cards are clean and stored in a dust-free environment. Do not use
cards with embedded contaminants in the surface.
3 Clean the inside of the Printer. See Cleaning inside the Printer .
4 Clean the Transfer Rollers. See Cleaning the Platen and Transfer Rollers .