Datacard Group SP Series - Manual (Page 16)

2-2
Getting started
User’s Guide for Express™ and Select™ Class Printers
•
Place the Express or Select printer in a clean office environment, protected from
any type of construction.
•
Store all supplies (ribbons, cards, etc.) in the original packaging until loaded in the
cartridges. Keep the original packaging closed.
•
Store all supplies in a clean, cool, dry location. See “Supply roll storage” on
page B-2 for information about the storage environment for Express or Select
supplies.
Selecting the site
After meeting general requirements, the site for the Express or Select printer should
meet the electrical, physical, and environmental requirements of the printer. Finally, be
sure to select an appropriate site for printer supplies.
Electrical requirements
The Express or Select printer requires the following electrical conditions for optimal
performance:
•
90-254 VAC at 50/60 Hz (The Express or Select printer automatically adjusts to
any power within this range.)
•
Single phase, 3-wire grounded receptacle only
The maximum input current for the Express or Select printer is 1.4 amps at 100 VAC
applied.
Physical requirements
The Express or Select printer requires an environment that accommodates its
physical dimensions and weight.
The printer weighs between 21 and 26.5 pounds or 9.7 and 11.9 kilograms.
The surface holding the printer might also need to bear the weight of other
equipment such as a PC and camera.
The dimensions are:
•
Width of 17.8 inches (54.1 cm) for E and S models
•
Width of 24 inches (65 cm) for S2 models
•
Depth of 8.8 inches (22.2 cm)
•
Height of 10 inches (25.4 cm)
i