Spectra Precision ProFlex 800 Reference Manual User Manual

Page 73

Using the Web Server

Select the desired source by simply clicking on the
corresponding row. The resulting mount point then
appears in the

Mount Point field located above the Load

Source Table button.

–

Send NMEA: Check this button when the rover operates
in a VRS network so that it can return its position to the
network through an NMEA message. Keep it cleared in
all other cases. (This option is automatically enabled
when you select a mount point for which the NMEA
message is requested.)

• At the bottom of the page, in the

Differential Port pane,

select the

Automatic option to let the receiver detect the

incoming differential stream automatically.

NOTE:

Automatic is the recommended choice for the

Differential Port setting because in this case, you don’t
need to define the ports receiving the two possible
differential streams.

• Click on the

Configure button to let the Web Server load all

your new parameters to the receiver. You just have now to
define the output messages (see Defining Output
Messages on page 64).