Spectra Precision ProFlex 800 Reference Manual - Manual (Page 288)

274
Integrating ProFlex 800 into Your Application
Checking Radio
Operation
Base With Ashtech Radio Transmitter
Script In the example below, it is assumed that the receiver will
generate differential data in RCTM V3.0 format. You may
replace RT3 with RT2 (RTCM2.3), ATOM, CMR or CMP
(CMR+), or DBEN. In the connection between the receiver
and the radio transmitter, port A is necessarily used on the
receiver side.
See $PASHS,RTC,TYP, $PASHS,RNX,TYP or
$PASHS,CMR,TYP if you want to change the default
messages and periods.
Enter the coordinates of the base:
$PASHS,POS,4717.93777,N,
130.541864,W,87.007
$PASHR,ACK*3D
Set the type of the internal radio transmit-
ter used: $PASHS,RDP,TYP,D,ADL
$PASHR,ACK*3D
Set the radio parameters (channel, proto-
col, air link speed) $PASHS,RDP,PAR,D,ADL,3,,0,9600
$PASHR,ACK*3D
Set the type of differential data that will be
generated by the receiver as well as the
port routing the data to the transmitter:
$PASHS,BAS,D,RT3
$PASHR,ACK*3D
Set the receiver to be a base transmitting
GPS data (+ GLONASS and/or SBAS
data):
$PASHS,CPD,MOD,BAS,0
$PASHR,ACK*3D
Action Command
Action Command
Query the radio settings
(channel, protocol, air link
speed,RF output power):
$PASHQ,RDP,PAR,D
$PASHR,RDP,PAR,D,ADL,,3,,0,9600,,
447.1000,447.1000,25.0,430450,V02.53,0,0,1,4F
SK*48
Query the channel table:
$PASHQ,RDP,CHT,D
$PASHR,RDP,CHT,ADL,2,1,464.5000,464.5000*2
7
Action Command
Set the name of the antenna connected to
the receiver: $PASHS,ANP,OWN,ASH111661
$PASHR,ACK*3D
Set the antenna reduction mode to ON,
so that all coordinates refer to the ground
mark:
$PASHS,ANR,ON
$PASHR,ACK*3D