Spectra Precision ProFlex 800 Reference Manual - Manual (Page 154)

140
Web Server Help Files Collection
NTRIP Server 1
Use this area to declare the type of connection used by the
base to deliver its data to an NTRIP caster via a mobile
communication network (port E) or directly through the
Internet (port P). See the description of each parameter in the
table below.
NTRIP Server 2
Use this area to declare the type of connection used by the
base to deliver its data to a second NTRIP caster, directly
Parameter Designation $PASHS
Connection
Choose the type of network connection used in the
receiver to connect to the NTRIP caster:
• External NTRIP Caster via Modem: The base is
connected to the Internet via its internal modem
used in GPRS mode (port E used).
• External NTRIP Caster via Ethernet: The base is
directly connected to the Internet through its Ether-
net port (port P used).
• Embedded NTRIP Caster: (Available only if the
NTRIP caster option is installed): The base delivers
its data to the embedded NTRIP caster.
MDM,..
NTR,PAR
Connect
Now
Check this button to let the receiver perform the
requested network connection after you have clicked
on the Configure button.
Address,
Port, Mount
Point, Pass-
word
Enter the network information relevant to the NTRIP
caster to which the base is expected to deliver its
data.
When the base delivers its data to the embedded
NTRIP caster, there is no password or IP address
needed. You only have to choose the mount point
through which the data from the base will be made
available to users through the NTRIP caster.
Message
Choose the type of message generated by the base.
Then place the mouse cursor over the ”I” sign (to the
right of the Message drop-down list) to read the
details of the currently set messages.
-