Spectra Precision ProFlex 800 Reference Manual - Manual (Page 237)

223
ProFlex 800 CORS Station
How to Safely Power the ProFlex 800 CORS
The setup below is recommended to power the ProFlex 800
CORS as it provides efficient protection from possible power
cuts. The slide switch located in the battery compartment
should be set to ON (pushed to the right) to make sure the
receiver will start automatically after a power shutdown.
Note that the battery used will not be charged from the AC/
DC supply kit. You will need a specific, separate charger for
this purpose.
The ProFlex 800 CORS can still use its internal battery in this
configuration to extend the operating time in case of
persisting power cuts.
Cable P/N 702473
SAE
Jack
Power Line
Fuse
“Y” Cable P/N 702501
AC/DC Power
Supply Kit
P/N 802064
External 9- to 36-V
DC Power Source
ProFlex 800 CORS
Battery
Charger
Power Line