Spectra Precision ProFlex 800 Reference Manual - Manual (Page 168)

154
Web Server Help Files Collection
Internal Radio Port
Use this area to turn on or off the internal radio connected to
port D.
Serial Ports
Use this area to set the receiver ports and declare the
different external devices connected to them. For each port
(ports A, B, F), set their parameters as explained in the table
below.
GPS
Check this button to enable GPS tracking. Clear it
otherwise.
GPS
GLONASS
Check this button to enable GLONASS tracking
(requires installed S option). Clear it otherwise.
GLO
SBAS
Check this button to enable SBAS tracking. Clear it
otherwise.
SBA
QZSS
Check this button to enable QZSS tracking. Clear it
otherwise.
QZS
GALILEO
Check this button to enable GALILEO tracking. Clear
it otherwise.
GAL
Parameter Designation $PASHS
Connection
This combo box is in fact a status (read-only) field
indicating the type of internal radio currently con-
nected to port D (ADL Foundation).
RDP,TYP
Power
Use these buttons to control power on the internal
radio. Selecting “On” will power up the internal radio
when later you click on the Configure button at the
bottom of the page. Likewise, selecting “Off” will turn
off the radio.
RDP,ON
or OFF
Parameter Designation $PASHS
Connection
Choose the device to which the port is connected. The
possible choices are:
• None/Cable: The port is not connected to any radio.
• ARF7474B EU: The port is connected to an exter-
nal license-free radio receiver (for use in Europe).
• ARF7474A NA: The port is connected to an exter-
nal license-free radio receiver (for use in North
America).
• XDL Rover: The port is connected to an external
receiver (PacCrest XDL Rover model)
RDP,TYP
(+ ECP)
Baud Rate
Choose a baud rate from the list. The selected rate
will be used by the port.
PRT
Mode
Port A only. Specify the type of serial link (“RS232 or
“RS422”) for Port A.
MDP
Parameter Designation $PASHS