Spectra Precision ProFlex 800 Reference Manual - Manual (Page 600)

586
Query Command Library
Parameters
Response Format Syntax
$PASHR,NTR,MTP,s1*cc
Parameters
Example
$PASHQ,NTR,MTP,P
$PASHR,NTR,MTP,NAN2*06
Relevant Set
Command
$PASHS,NTR,MTP
NTR,TBL: Source Table
Function This command is used to read the source table stored in the
receiver.
Command Format Syntax
$PASHQ,NTR,TBL[*cc]
Response Format Syntax
$PASHR,NTR,TBL
SOURCETABLE 200 OK
Parameter Description Range
c1
Internet port used for the connection to the embed-
ded NTRIP caster.
• E: Internal modem
• P: Ethernet stream 1
• Q: Ethernet stream 2
If c1 is omitted, the receiver will return the mount
point name corresponding to the port last defined
through the $PASHS,NTR,PAR command.
E, P, Q
*cc Checksum *00-*FF
Parameter Description Range
s1
NTRIP mount point name
If “OFF”, the port is not connected to
any NTRIP caster mount point.
100 characters max.
or “OFF”
*cc Checksum *00-*FF