Spectra Precision ProFlex 800 Reference Manual - Manual (Page 294)

280
Integrating ProFlex 800 into Your Application
Ending the Direct
IP Connection
NTRIP Station
By following the script described below, and according to the
terminology used in the NTRIP standard, the receiver will be
configured to operate as an “NTRIP server”, that is, a station
capable of delivering its data to an NTRIP caster.
Script In the example below, it is assumed that the receiver will
generate differential data in RCTM V3.0 format. You may
replace RT3 with RT2 (RTCM2.3), ATOM, CMR or CMP
(CMR+) or DBEN.
See $PASHS,RTC,TYP, $PASHS,RNX,TYP or
$PASHS,CMR,TYP if you want to change the default
messages and periods.
Action Command
Ending the Direct IP connection:
$PASHS,DIP,OFF
$PASHR,ACK*3D
Action Command
Set the name of the antenna connected to
the receiver: $PASHS,ANP,OWN,ASH111661
$PASHR,ACK*3D
Set the antenna reduction mode to ON, so
that all coordinates refer to the ground
mark:
$PASHS,ANR,ON
$PASHR,ACK*3D
Set the antenna height (for example a slant
height of 1.45 meters was measured):
NOTE: When a slant height is entered, you
also need to enter the antenna radius and
the ARP-to-SHMP vertical offset (negative
if ARP is below SHMP).
$PASHS,ANT,1.45,0.0921,-0.0516
$PASHR,ACK*3D
Enter the coordinates of the base:
$PASHS,POS,4717.93777,N,
130.541864,W,87.007
$PASHR,ACK*3D
Set the modem and GPRS parameters
(Power mode, PIN code, APN settings, IP
protocol, auto-dial, re-dials, 2G/3G):
$PASHS,MDM,PAR,PWR,AUT,
PIN,1234,APN,ssx.com,LGN,Ssx,
PWD,ssx3,IPT,1,ADL,Y,RNO,3,
NET,0
$PASHR,ACK*3D
Set the modem in GPRS and TCP/IP
modes: $PASHS,MDM,PAR,PTC,1,IPT,0
$PASHR,ACK*3D
Turn on the modem (unless the modem has
been set in automatic power mode): $PASHS,MDM,ON
$PASHR,ACK*3D