Spectra Precision ProFlex 800 Reference Manual - Manual (Page 194)

180
Web Server Help Files Collection
General Settings
G-File Conversion
Parameter Designation $PASHS
Run Sessions
Use this button to enable or disable the execution
of the programmed sessions. SES,ON
SES,OFF
Reference Day
Enter the day of year (1-366) when the first pro-
grammed session will start. Should be greater than
or equal to the current day of year for a postponed
start, otherwise “1” for immediate start.
SES,PAR
Offset per Day
Use this field if you wish to introduce minutes and
seconds of time shift so that every day, the same
GPS constellation is visible from the same site
during the same session (typical value: 4 minutes).
SES,PAR
Site Name
Give a name to the site where data are recorded.
G-file names will be derived from this name.
SES,PAR
Storage
Choose the storage media where record files will
be stored.
SES,PAR
Ring File Mem-
ory
Enabling this option will allow the receiver to delete
the oldest record file when the memory used is
almost full (less than 15 Mbytes still free).
This will allow the receiver to constantly log data
without external intervention. When this function is
enabled/disabled for sessions, it is as well for “con-
ventional” recording.
RFM
Power Off
Receiver
Between Ses-
sions
Enabling this option will allow the receiver to switch
automatically to sleep mode at the end of each ses-
sion and to be woken up just before the next ses-
sion starts.
With this option disabled, the receiver will stay pow-
ered up even between sessions.
SES,PAR
Recording and
Output Eleva-
tion Mask Set the recording elevation mask, in degrees
(default: 5°). Data from masked satellites will not
be recorded.
SES,PAR
Data Type
A read-only field identifying the type of raw data
recorded.
Parameter Designation $PASHS
RINEX 2.11
Use this option to convert G-files to RINEX 2.11 for-
mat.
SES,PAR
RINEX 3.01
Use this option to convert G-files to Rinex 3.01 for-
mat.
SES,PAR