Spectra Precision ProFlex 800 Reference Manual - Manual (Page 721)

707
Chapter 13. Other Procedures & Memos
Special Button Combinations Summary
Refer to Special Button Combinations on page 15 for
more information.
Reset Procedure
The receiver may be reset to the default settings using the
Log+Scroll+Power button combination. Release the three
buttons only after the logo is displayed.
The reset procedure is also used to poll the radio module. If
a new module is detected, the receiver will update its
database so it can successfully communicate with the new
module.
The default settings can also be restored using the
$PASHS,INI command. With this command, you can ask
more than a simple “restore default settings”. See INI:
Receiver Initialization on page 393.
Firmware Upgrade Procedure
Firmware upgrades can be downloaded from the Spectra
Precision website as one or more compressed “.tar.bz2” files.
The file(s) provided, as well a the step-by step upgrade
procedure are given in the relevant Release Note.
Completing a firmware upgrade procedure may take up to 30
minutes. For this reason, it must be run with the receiver
Button
Combination
Receiver
State
Function
Power+Log+Scroll OFF Restores Factory Settings.
Power+Scroll OFF Initiates firmware update from USB key.