OM SYSTEM OM-1 Mirrorless Camera - Manual (Page 299)

299 EN
Information
10
4
Adjust flash settings.
• Highlight items using the
FGHI
buttons and rotate the front dial to choose
settings.
Group, flash control mode
Flash compensation
± 0.0 ± 0.0
A Mode RC RC
0.0
5.6 250 P
Ch1 Low
TTL
Off
Off
A
Small
1/ Auto
ISO
#
#
x
G 3
0 + -
C
B
[ 1:02:03 ]
1023
r ±
F
200
WB Auto
Channel
Optical signal strength
Flash mode
Group
Choose a group. Changes to settings apply to all units in the
selected group. The unit mounted on the camera works as a
member of Group A.
Flash control mode
Choose a flash mode.
Flash compensation
Adjust flash output. When [Manual] is selected for flash mode,
you can a value for manual flash output.
Optical signal
strength
Choose the brightness of the optical control signals emitted by
the flash units. Choose [High] if you have placed flash units at
close to the maximum distance from the camera. This setting
applies to all groups.
Flash mode
Choose
#
(standard) or FP (super FP). Choose super FP for
shutter speeds faster than the flash sync speed. This setting
applies to all groups.
Channel
Choose the channel used for flash control. Change the
channel if you find that other light sources in the area are
interfering with remote flash control.
5 Set the unit mounted on the camera to [TTL AUTO].
• Flash control settings for the FL-LM3 can only be adjusted using the camera.
#
Position the wireless units with the remote sensors facing the camera.
# Take pictures after confirming that the flash units are charged.