PLANET XGS3-24042 User Manual
Page 665
80-19
[no] loop-detection-count <count>
optional
Configure the maximum hop count of LDP
loop detection, whose default value is 255,
the no operation will restore the default
value.
(3) Configure the LDP specified peers
Command
Explanation
Router Configuration Mode
[no] targeted-peer <ip-addr>
optional
Configure the remote peer of the LDP
targeted destination.
(4) Configure other LDP parameters
1) Configure the aging time or interval of each LDP timer
2) ID Configure LDP router ID
3) Configure the TCP interface address of LDP
4) Configure the LDP to discover peers via multicast Hellos or not,
5) Configure the LDP to import BGP routes or not.
6) Configure the LDP to enable label merging capability or not.
7) Configure the LDP to transmit release messages or not.
8) Configure the LDP to retry or not when the label request is rejected
9) Hello Configure the LDP to receive Hello from the specified targets
Command
Explanation
Router Configuration Mode
[no] keepalive-interval <interval>
Optional
Configure the interval of sending LDP
keepalive messages, whose default value
is 10 seconds; the no operation will restore
the default value
[no] keepalive-timeout <time-val>
Optional
Configure the LDP keepalive timeout,
whose default value is 30 seconds; the no
operation will restore the default value
[no] Hello-interval <Hello-interval>
Optional
Configure the interval of sending multicast
HELLO messages, whose default value is
5 seconds; the no operation will restore the
default value