PLANET XGS3-24042 - Manual (Page 173)

18-10
mls qos map (cos-dp | dscp-dscp
to | dscp-intp
to | dscp-dp
to )
no mls qos map (cos-dp | dscp-dscp |
dscp-intp | dscp-dp)
mls qos map intp-dscp
no mls qos map intp-dscp
Set the priority mapping for QoS, the
no command restores the default
mapping value.
6. Clear accounting data of the specific ports or VLANs
Command Explanation
Admin Mode
clear mls qos statistics [interface
| vlan ]
Clear accounting data of the specified
ports or VLAN Policy Map. If there are no
parameters, clear accounting data of all
policy map.
7. Show configuration of QoS
Command Explanation
Admin Mode
show mls qos maps [cos-dp | dscp-dscp |
dscp-intp | dscp-dp | intp-dscp]
Display the configuration of QoS mapping.
show class-map [] Display the classified map information of
QoS.
show policy-map [] Display the policy map information of
QoS.
show mls qos {interface []
[policy | queuing] | vlan }
Displays QoS configuration information on
a port.
18.3 QoS Example
Example 1:
Enable QoS function, change the queue out weight of port ethernet 1/0/1 to 1:1:2:2:4:4:8:8, set the port in
trust CoS mode without changing DSCP value, and set the default CoS value of the port to 5.
The configuration steps are listed below:
Switch#config
Switch(config)# mls qos queue weight 1 1 2 2 4 4 8 8