PLANET XGS3-24042 - Manual (Page 281)

35-2
2. VRF configuration
Command Explanation
Global mode
ip route vrf <name> {<ip-prefix>
<mask>|<ip-prefix/}
{|>}
[<distance>]
no ip route vrf {
|}
[|]
[]
Configure the static route, the
no command will delete the
static route.
35.4 Static Route Configuration Examples
The figure shown below is a simple network consisting of three layer3 switches, the network mask for all
switches and PC is 255.255.255.0. PC-A and PC-C are connected via the static route set in SwtichA and
SwitchC; PC3 and PC-B are connected via the static route set in SwtichC to SwitchB; PC-B and PC-C is
connected via the default route set in SwitchB.
Figure 35-1 Static Route Configurations
Configuration steps:
Configuration of layer3 SwitchA
Switch#config
Switch (config) #ip route 10.1.5.0 255.255.255.0 10.1.2.2
Configuration of layer3 SwitchC
Switch#config
Next hop use the partner IP address
SwitchB
PC-A:10.1.1.2 PC-B:10.1.4.2
vlan3:10.1.5.1
vlan1:10.1.1.1
vlan2:10.1.2.1
vlan2:10.1.4.1
vlan2:10.1.2.2 vlan1:10.1.3.2
SwitchA
SwitchC
vlan1:10.1.3.1
PC-C:10.1.5.2