PLANET XGS3-24042 - Manual (Page 330)

39-7
Command Explanation
Admin Mode
debug ipv6 ospf redistribute message
send
no debug ipv6 ospf redistribute
message send
debug ipv6 ospf redistribute route
receive
no debug ipv6 ospf redistribute route
receive
Enable or disable debugging of sending
command from OSPFv3 process redistributed
to other OSPFv3 process routing.
Enable or disable debugging of received
routing message from NSM for OSPFv3
process.
（4） Configure Other Parameters of OSPFv3 Protocol
1） Configure OSPFv3 STUB Area & Default Routing Cost
2） Configure OSPFv3 Virtual Link
Commands Explanation
OSPFv3 Protocol Configuration Mode
timers spf
no timers spf
Configure OSPFv3 SPF timer. The no
timers spf command recovers default
value.
area <id> stub [no-summary]
no area stub [no-summary]
area <id> default-cost <cost>
no area <id> default-cost
area <id> virtual-link A.B.C.D [instance-id
<instance-id> INTERVAL]
no area <id> virtual-link A.B.C.D
[|INTERVAL]
Configure parameters in OSPFv3 area
(STUB area, Virtual link). The no
command restores default value.
3）Configure the priority of the interface when electing designated layer3 switch (DR).
Commands Explanation
Interface Configuration Mode
IPv6 ospf priority <priority>
[instance-id ]
no IPv6 ospf priority [instance-id
]
Sets the priority of the interface in “designated
layer3 switch” election; the “no IPv6 ospf
priority [instance-id ]” command restores
the default setting.
3. Disable OSPFv3 Protocol
Commands Explanation
Global Mode