PLANET XGS3-24042 - Manual (Page 343)

40-9
[..]command deletes
the AS from the AS
confederation.
5．Configure a Route Reflector
（1） The following commands can be used to configure route reflector and its clients.
Command Explanation
BGP configuration mode
neighbor route-reflector-client
no neighbor route-reflector-client
Configure the current switch as
route reflector and specify a
client. the no neighbor
route-reflector-client
commands format deletes a
client.
（2） If there are more than one route reflectors in the cluster, the following commands can
configure cluster-id
Command Explanation
BGP configuration mode
bgp cluster-id
no bgp cluster-id
Configure cluster id; format “no” of the no
bgp cluster-id command cancels the
cluster id configuration.
（3） If the route reflector from clients to clients is needed, the following commands can be used.
Command Explanation
BGP configuration mode
bgp client-to-client reflection
no bgp client-to-client reflection
Configure the allowance of the route
reflector from clients to clients; the no bgp
client-to-client reflection command forbids
this allowance.
6．Configure Peer Groups
（1） Create peer groups
Command Explanation
BGP configuration mode
neighbor peer-group
no neighbor peer-group
Create peer groups; the no neighbor
peer-group command deletes
peer groups.