PLANET XGS3-24042 - Manual (Page 392)

45-10
Switch(config-router)#enable
Switch(config-router)#bfd enable
# Configure Switch B
Switch#config
Switch(config)#bfd mode passive
Switch(config)#interface vlan 2
Switch(config-ip-vlan2)#ip address 192.16.0.102 255.255.255.0
Switch(config)#router vrrp 1
Switch(config-router)#virtual-ip 192.168.0.10
Switch(config-router)#interface vlan 1
Switch(config-router)#enable
Switch(config-router)#bfd enable
45.4 BFD Troubleshooting
When the problem of BFD function happens, please check whether the problem is resulted by the following
reasons:
 Check whether the route protocol neighbor is established successfully. If no route protocol neighbor is
established successfully, here BFD can not process the detection.
 Check whether the configured source-ip is correct for linkage with static route, if the connectivity of IP
between two peers fails, BFD can not process the detection.
 Check whether VRRP group is established successfully for linkage with VRRP protocol. If no VRRP
group is established successfully, here BFD can not process the detection.