PLANET XGS3-24042 - Manual (Page 379)

43-13
(1) The configuration of device A
1. The configuration step
 Enable IPv6 function.
SwitchA(config)#ipv6 enable
 Create the interface VLAN 11 and its address.
SwitchA(config)#vlan 11
SwitchA(config-vlan11)#switchport interface ethernet 1/0/11
SwitchA(config-vlan11)#exit
SwitchA(config)#interface vlan 11
SwitchA(config-if-vlan11)#ipv6 address 2000:3000:1000::1/64
 Configure the IPv6 static route to switch B from interface Vlan11.
SwitchA(config)#ipv6 route 2005:3000:1000::1/64 2000:3000:1000::2
 Configure tunnel interface: source, destination and type.
SwitchA(config)#interface tunnel 1
SwitchA(config-if-tunnel1)# tunnel source 2000:3000:1000::1
SwitchA(config-if-tunnel1)# tunnel destination 2005:3000:1000::1
SwitchA(config-if-tunnel1)# tunnel mode gre ipv6
SwitchA#show gre tunnel
name mode source destination
Tunnel1 gre ipv6 2000:1000:3000::1 2005:1000:3000::1
The configuration of GRE tunnel is successful.
 Configure the IPv4 address of the tunnel interface. To run OSPF routing protocol, the interface address
must be configured.
SwitchA (config-if-tunnel1)#ip address 100.1.1.1 255.255.255.0
 Configure the interface VLAN10 and its address.
SwitchA(config)#vlan 10
SwitchA(config-vlan10)#switchport interface ethernet 1/0/10
SwitchA(config-vlan10)#exit
SwitchA(config)#interface vlan 10
SwitchA(config-if-vlan10)# ip address 10.1.1.2 255.255.255.0
SwitchA(config-if-vlan10)#exit
 Configure loopback group and enable the tunnel to quote this loopback group.
SwitchA (config)#loopback-group 1
SwitchA (config-if-ethernet1/0/12)#loopback-group 1