PLANET XGS3-24042 - Manual (Page 301)

37-7
37.3 RIPng Configuration Examples
37.3.1 Typical RIPng Examples
Figure 37-1 RIPng Example
As shown in the above figure, a network consists of three layer 3 switches. SwitchA and SwitchB connect to
SwitchC through interface vlan1 and vlan2. All the three switches are running RIPng. Assume SwitchA
（VLAN1：2001:1:1::1/64 and VLAN2：2001:1:1::1/64）exchange update information with SwitchB（VLAN1：
2001:1:1::2/64） only, update information is not exchanged between SwitchA and SwitchC（VLAN1：
2001:1:1::2/64）.
The configuration for SwitchA, SwitchB and SwitchC is shown below:
Layer 3 SwitchA
Enable RIPng protocol
SwitchA(config)#router IPv6 rip
SwitchA(config-router)#exit
Configure the IPv6 address in vlan1 and configure vlan1 to run RIPng
SwitchA#config
SwitchA(config)# interface Vlan1
SwitchA(config-if-Vlan1)# IPv6 address 2000:1:1::1/64
SwitchA(config-if-Vlan1)#IPv6 router rip
SwitchA(config-if-Vlan1)#exit
Configure the IPv6 address in vlan2 and configure vlan2 to run RIPng
SwitchA(config)# interface Vlan2
SwitchA(config-if-Vlan2)#IPv6 address 2001:1:1::1/64
SwitchA(config-if-Vlan2)#IPv6 router rip
SwitchA(config-if-Vlan2)#exit
Configure the interface vlan1 do not send RIPng messages to SwitchC
SwitchA(config)#
SwitchA
SwitchC
SwitchB
Interface VLAN1:
2000:1:1::1/64
Interface VLAN1:
2000:1:1::2/64
Interface VLAN2:
2001:1:1::1/64
Interface VLAN1:
2001:1:1::2/64