PLANET XGS3-24042 - Manual (Page 440)

48-39
[no] multicast destination-control
（required）
Globally enable IPv4 and IPv6
destination control. The no operation
of this command will globally disable
destination control. All of the other
configuration can only take effect after
globally enabled. The next is
configuring destination control rules,
which are similar.
Next is to configure destination control rule. It is similar to source control, except to use ACL No. of
6000-7999.
Command Explanation
Global Configuration Mode
[no] access-list <6000-7999> {deny|permit} ip
{{<source> <source-wildcard>}|{host-source
<source-host-ip>}|any-source}
{{<destination>
<destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
The rule used to configure destination
control. This rule does not take effect
until it is applied to source IP or
VLAN-MAC and port. Using the NO
form of it can delete specified rule.
The last is to configure the rule to specified source IP, source VLAN MAC or specified port. It is noticeable that,
due to the above situations, these rules can only be used globally in enabling IGMP-SNOOPING. And if
IGMP-SNOOPING is not enabled, then only source IP rule can be used under IGMP Protocol. The
configuration commands are as follows:
Command Explanation
Port Configuration Mode
[no] ip multicast destination-control
access-group <6000-7999>
Used to configure the rules destination
control uses to port, the NO form
cancels the configuration.
Global Configuration Mode
[no] ip multicast destination-control
<1-4094> > access-group
<6000-7999>
Used to configure the rules destination
control uses to specify VLAN-MAC, the
NO form cancels the configuration.
[no] ip multicast destination-control
> access-group
<6000-7999>
Used to configure the rules destination
control uses to specified IP address/net
mask, the NO form cancels the
configuration.
3． Multicast Strategy Configuration
Multicast Strategy uses the manner of specifying priority for specified multicast data to achieve and guarantee
the effects the specific user requires. It is noticeable that multicast data can not get a special care all along
unless the data are transmitted at TRUNK port. The configuration is very simple, it has only one command, i.e.