PLANET XGS3-24042 - Manual (Page 340)

40-6
BGP configuration mode
neighbor { <ip-address> | }
soft-reconfiguration inbound
no neighbor { <ip-address> | }
soft-reconfiguration inbound
This command can store routing
information from neighbors and
peers; the no neighbor
{ <ip-address> | }
soft-reconfiguration inbound
command cancels the storage of
routing information.
Admin Mode
clear ip bgp {<*>|| external|peer-group
|} soft in
Configure BGP inbound soft
reconfiguration.
4. Configure BGP Weights
Command Explanation
BGP configuration mode
neighbor { | } weight
no neighbor { | }
Configure BGP neighbor weights;
the no neighbor { |
} command recovers default
weights.
5. Configure BGP Route Filtering policy based on neighbor
Command Explanation
BGP configuration mode
neighbor {|} distribute-list
{<1-199>|<1300-2699>|} {in|out}
no neighbor {|} distribute-list
{<1-199>|<1300-2699>|} {in|out}
Filter neighbor routing
updating information. The no
neighbor { |
} distribute-list
{<1-199>|<1300-2699>|
} {in|out} command
cancels routing filter.
6. Configure Next-Hop
1) Set Next-Hop as the switch’s address
Command Explanation
BGP configuration mode
neighbor { | }
next-hop-self
no neighbor { | }
next-hop-self
While sending route Next-Hop set Next-Hop
as the switch’s address; the no neighbor
{ | } next-hop-self
command cancels the setting.
2）Cancel default Next-Hop through route map