PLANET XGS3-24042 - Manual (Page 565)

60-9
Switch(config)#interface ethernet 1/0/2
Switch(config-if-ethernet1/0/2)# switchport mode hybrid
Switch(config-if-ethernet1/0/2)# switchport hybrid native vlan 1
Switch(config-if-ethernet1/0/2)# switchport hybrid allowed vlan 1;8;10 untag
Switch(config-if-ethernet1/0/2)# mac-authentication-bypass enable
Switch(config-if-ethernet1/0/2)# mac-authentication-bypass enable guest-vlan 8
Switch(config-if-ethernet1/0/2)#exit
Switch(config)#interface ethernet 1/0/3
Switch(config-if-ethernet1/0/3)# switchport mode access
Switch(config-if-ethernet1/0/3)# mac-authentication-bypass enable
Switch(config-if-ethernet1/0/3)#exit
Switch(config)#interface ethernet 1/0/4
Switch(config- if-ethernet1/0/4)# switchport mode trunk
60.4 MAB Troubleshooting
If there is any problem happens when using MAB function, please check whether the problem is caused by
the following reasons:
 Make sure global and port MAB function are enabled;
 Make sure the correct username and password of MAB authentication are used;
 Make sure the radius-server configuration is correct. Complete MAB offline-detect through query
whether dynamic MAC is exist. Do not delete the binding if the MAC address exists in MAC address
table. The actual offline time without the traffic is 1-2 MAC aging period add 0-1 MAB offline-detect time.