Epson WorkForce Pro WF-R8590 DTWF - Manual (Page 53)

& “Available Paper and Capacities” on page 43
Loading Envelopes and Precautions
Envelopes can only be loaded in the rear paper feed. Load envelopes short edge first at the center with the flap
facing down, and slide the edge guides to the edges of the envelopes.
❏ Fan and align the edges of the envelopes before loading. When the stacked envelopes are puffed up with air,
press them down to flatten them before loading.
❏ Do not use envelopes that are curled or folded. Using these envelopes causes paper jams and smears on the
printout.
❏ Do not use envelopes with adhesive surfaces on the flaps or window envelopes.
❏ Avoid using envelopes that are too thin, as they may curl during printing.
Related Information
& “Available Paper and Capacities” on page 43
& “Loading Paper in the Rear Paper Feed” on page 49
Setting the Paper Size and Paper Type for Each Paper
Source
After loading paper, set the paper size and paper type for each paper source on the control panel. Once these
settings have been made, when automatic paper source selection is enabled, paper is automatically fed from a
paper source that matches the paper size and type settings for the print job. You do not need to select the paper
source each time you print.
1. Enter Setup from the home screen.
2. Select Paper Setup.
3. Select a paper source.
4. Select the paper size and paper type you loaded.
User's Guide
Loading Paper
53