Epson 440 - Manual (Page 100)

EPSON Stylus Color 440/640/740 Revision A
Chapter 4 Disassembly and Assembly 100
4.1 Overview
This chapter describes procedures for disassembling the main
components of EPSON Stylus Color 440/640/740. Unless otherwise
specified, disassembly units or components can be reassembled by
reversing the disassembly procedure. Therefore, no assembly
procedures are included in this chapter. Precautions for any
disassembly or assembly procedure are described under the heading
“CHECK POINT”. Any adjustments required after disassembling the
units are described under the heading “REQUIRED ADJUSTMENT”.
4.1.1 Precautions for Disassembling the Printer
See the precautions given under the heading “WARNING” and
“CAUTION” in the right column and the following page, respectively,
when disassembling or assembling EPSON Stylus Color 440/640/740.
W A R N I N G
Disconnect the power cable before disassembling or
assembling the printer.
Wear protective goggles to protect your eyes from
ink. If ink gets in your eye, flush the eye with fresh
water and see a doctor immediately.
If ink comes into contact with your skin, wash it off
with soap and water. If irritation occurs, contact a
physician.
A lithium battery is installed on the main board of this
printer. Be sure to observe the following instructions
when serving the battery:
Keep the battery away from any metal or other
batteries so that electrodes of the opposite polarity do
not come in contact with each other.
Do not heat the battery or put it near fire.
Do not solder on any part of the battery. (Doing so may
result in leakage of electrolyte from the battery,
burning or explosion. The leakage may affect other
devices close to the battery.)
Do not charge the battery. (An explosion may be
generated inside the battery, and cause burning or
explosion.)
Do not dismantle the battery. (The gas inside the
battery may hurt your throat. Leakage, burning or
explosion may also be resulted.)
Do not install the battery in the wrong direction. (This
may cause burning or explosion.)
Danger of explosion if the battery is incorrectly
replaced. Replace only with the same or equivalent
type recommended by the manufacture. Dispose the
used batteries according to government’s law and
regulations.