Yaskawa Sigma-5 User Manual: Design and Maintenance - Linear Motors MECHATROLINK-III Communications Reference - Manual (Page 348)

9 Appendix
9-50
Pn801 0003
Application Function Select 6
(Software LS)
Immediately
Pn803 10 Origin Range Immediately
Pn804 1073741823 Forward Software Limit Immediately
Pn806 -1073741823 Reverse Software Limit Immediately
Pn808 0 Absolute Encoder Origin Offset
Immediately
∗1
Pn80A 100 1st Linear Acceleration Constant
Immediately
∗2
Pn80B 100 2nd Linear Acceleration Constant
Immediately
∗2
Pn80C 0
Acceleration Constant Switching
Speed Immediately
∗2
Pn80D 100 1st Linear Deceleration Constant
Immediately
∗2
Pn80E 100 2nd Linear Deceleration Constant
Immediately
∗2
Pn80F 0
Deceleration Constant Switching
Speed Immediately
∗2
Pn810 0
Exponential Function Acceleration/
Deceleration Bias Immediately
∗2
Pn811 0
Exponential Function Acceleration/
Deceleration Time Constant Immediately
∗2
Pn812 0 Movement Average Time
Immediately
∗2
Pn814 100
Final Travel Distance for External
Positioning Immediately
∗2
Pn816 0000 Homing Mode Setting
Immediately
∗2
Pn817 50
Homing Approach Speed
(Homing Approach Speed 1) Immediately
∗2
Pn818 5
Homing Creep Speed
(Homing Approach Speed 2) Immediately
∗2
Pn819 100 Final Travel Distance for Homing
Immediately
∗2
Pn81E 0000 Input Signal Monitor Selection Immediately
Pn81F 0010 Command Data Allocation After restart
Pn820 0 Forward Latching Allowable Area Immediately
Pn822 0 Reverse Latching Allowable Area Immediately
Pn824 0000 Option Monitor 1 Selection Immediately
Pn825 0000 Option Monitor 2 Selection Immediately
Pn827 100
Linear Deceleration Constant 1 for
Stopping Immediately
∗2
Pn829 0
SVOFF Waiting Time (SVOFF at
deceleration to stop)
Immediately
Pn82A 1813 Option Field Allocation 1 After restart
Pn82B 1D1C Option Field Allocation 2 After restart
Pn82C 1F1E Option Field Allocation 3 After restart
∗1. Enabled after the SENS_ON is entered.
∗2. Change the setting when the reference is stopped (DEN is set to 1), because the change will affect the output during
operation.
(cont’d)
Parameter
Factory
Setting
Name
When
Enabled