Yaskawa Sigma-5 User Manual: Design and Maintenance - Linear Motors MECHATROLINK-III Communications Reference - Manual (Page 157)

5.1 Type of Adjustments and Basic Adjustment Procedure
5-7
5
Adjustments
Analog monitor output at n.
00 (motor moving speed setting)
(4) Related Parameters
Use the following parameters to change the monitor factor and the offset.
+6 V
-6 V
-600
+600
+8 V
-8 V
-800
+800
+10 V (approx.)
-10 V (approx.)
+6 V
-6 V
-6000
+6000
Analog monitor
output voltage [V] Analog monitor
output voltage[V]
When multiplier is set to × 1: When multiplier is set to × 10:
Motor speed
[mm/s] Motor speed
[mm/s]
Note: Linear effective range: within ± 8 V
Output resolution: 16-bit
Linear
Pn550
Analog Monitor 1 Offset Voltage
Classification
Setting Range Setting Unit Factory Setting When Enabled
-10000 to 10000 0.1 V 0 Immediately Setup
Pn551
Analog Monitor 2 Offset Voltage
Classification
Setting Range Setting Unit Factory Setting When Enabled
-10000 to 10000 0.1 V 0 Immediately Setup
Pn552
Analog Monitor Magnification ( × 1)
Classification
Setting Range Setting Unit Factory Setting When Enabled
-10000 to 10000 × 0.01 100 Immediately Setup
Pn553
Analog Monitor Magnification ( × 2)
Classification
Setting Range Setting Unit Factory Setting When Enabled
-10000 to 10000 × 0.01 100 Immediately Setup
Speed Position Force
Speed Position Force
Speed Position Force
Speed Position Force