Yaskawa Sigma-5 User Manual: Design and Maintenance - Linear Motors MECHATROLINK-III Communications Reference - Manual (Page 109)

4.4 Trial Operation
4-21
4
Op
er
at
io
n
4.4 Trial Operation
This section describes a trial operation using MECHATROLINK-III communications.
4.4.1 Inspection and Checking before Trial Operation
To ensure safe and correct trial operation, inspect and check the following items before starting trial operation.
(1) Servomotors
Inspect and check the following items, and take appropriate measures before performing trial operation if any
problem exists.
• Are all wiring and connections correct?
• Are all nuts and bolts securely tightened?
Note: When performing trial operation on a servomotor that has been stored for a long period of time, perform the inspec-
tion according to the procedures described in 1.7 Inspection and Maintenance.
(2) SERVOPACKs
Inspect and check the following items, and take appropriate measures before performing trial operation if any
problem exists.
• Are all wiring and connections correct?
• Is the correct power supply voltage being supplied to the SERVOPACK?