Yaskawa Sigma-5 User Manual: Design and Maintenance - Linear Motors MECHATROLINK-III Communications Reference - Manual (Page 321)

9.1 List of Parameters
9-23
9
Ap
pend
ix
Pn586 2
Motor Running Air-cooling
Ratio
0 to 100
1%/
maximum
speed
0 Immediately Setup − −
Pn587
2
Polarity Detection for
Absolute Scale Selection
0000 to 0001 − 0000 Immediately Setup − −
Pn600 2
Regenerative Resistor
Capacity
∗2
Depends on
SERVO-
PACK
Capacity
∗3
10 W 0 Immediately Setup − 3.7.2
Pn601 2 Reserved (Do not change.) – – 0 – – − –
Pn621 to
Pn628
*11
–
SERVOPACK: Safety
Module Parameters
– – – – – – –
∗2. Normally set to "0." When using an external regenerative resistor, set the capacity (W) of the regenerative resistor.
∗3. The upper limit is the maximum output capacity (W) of the SERVOPACK.
∗11. These parameters can be set in SERVOPACKs with safety modules. For details, refer to Σ -V Series User’s Manual,
Safety Module (No.: SIEP C720829 06).
(cont’d)
Parameter
No.
Size Name
Setting
Range
Units
Factory
Setting
When
Enabled
Classi-
fication
Profile
Reference
Section
4th
digit 3rd
digit 2nd
digit 1st
digit
n.
Polarity Detection for Absolute Scale Selection
0
1
Reserved (Do not change.)
Does not detect polarity.
Detects polarity.
Reserved (Do not change.)
Reserved (Do not change.)