Introduction – HEIDENHAIN TNC 426B (280 472) Touch Probe Cycles User Manual
Page 7
HEIDENHAIN TNC 426, TNC 430
V
1.1 General Information on Touch Probe Cycles ..... 2
Touch Probe Cycles in the Manual and Electronic Handwheel Modes ..... 3
Touch probe cycles for automatic operation ..... 3
1.2 Before You Start Working with Touch Probe Cycles! ..... 5
Maximum traverse to touch point: MP6130 ..... 5
Safety clearance to touch point: MP6140 ..... 5
Orient the infrared touch probe to the programmed probe direction: MP6165 (as of 280 476-10) ..... 5
Multiple measurement: MP6170 ..... 5
Confidence interval for multiple measurement: MP6171 ..... 5
Touch trigger probe, probing feed rate: MP6120 ..... 6
Touch trigger probe, rapid traverse for pre-positioning: MP6150 ..... 6
Measuring touch probe, probing feed rate: MP6360 ..... 6
Measuring touch probe, rapid traverse for pre-positioning: MP6361 ..... 6