1 general information on touch probe cycles, Function – HEIDENHAIN TNC 426B (280 472) Touch Probe Cycles User Manual
Page 14
![background image](https://www.manualsdir.com/files/816107/content/doc014.png)
2
1 Introduction
1
.1 Gener
a
l Inf
o
rm
ation on T
ouc
h Pr
obe Cy
cles
1.1 General Information on Touch
Probe Cycles
Function
Whenever the TNC runs a touch probe cycle, the 3-D touch probe
approaches the workpiece in one linear axis. This is also true during an
active basic rotation or with a tilted working plane. The machine tool
builder determines the probing feed rate in a machine parameter (see
“Before You Start Working with Touch Probe Cycles” later in this
chapter).
When the probe stylus contacts the workpiece,
n
the 3-D touch probe transmits a signal to the TNC: the coordinates
of the probed position are stored,
n
the touch probe stops moving, and
n
returns to its starting position in rapid traverse.
If the stylus is not deflected within a distance defined in MP 6130), the
TNC displays an error message.
The TNC must be specially prepared by the machine tool
builder for the use of a 3-D touch probe.
If you are carrying out measurements during program run,
be sure that the tool data (length, radius) can be used from
the calibrated data or from the last TOOL CALL block
(selected with MP7411).
If you are working alternately with a triggering and a
measuring touch probe, be sure that
n
You have selected the correct touch probe in MP 6200.
n
The measuring and triggering touch probes are never
connected to the control at the same time.
The TNC cannot detect which probe is actually in the
spindle.
Y
X
Z
F
F MAX