Verifying your installation – Grass Valley MRC v.1.2 User Manual
Page 19
9
Miranda Router Configurator
User’s Guide
6 After several seconds, the installation will complete. The completion window appears:
Uncheck ‘Launch Miranda Router Configurator’ if you do not want to run MRC immediately.
7 Click ‘Finish’.
Verifying Your Installation
After you have installed MRC, launch MRC by clicking its desktop icon or selecting
‘NVISION > Miranda Router Configurator’ from the PC’s list of programs. Then, from MRC’s navi-
gation pane, click ‘Ethernet Settings’ to open the ‘Ethernet Settings’ page and view a list of
control cards in the network.
Click ‘Refresh List’ in the ‘Ethernet Settings’ page.
Examine the list of control cards and note whether any of the following problems exist:
•
No entries in the list.
Either you have no network, the network is not properly connected to the PC, or there are no
control cards on the network. Ensure that the PC has an Ethernet connection to the Ethernet
switch for the network.
Click the ‘Network Interfaces’ button in MRC’s ‘NVISION Series Products’ page to determine to
which subnets your configuration PC is connected.
One of your router frames might be disconnected or receiving no power. Check Ethernet
connections, power connections, and power supplies of the router.
•
Entries read IP Conflict. There might be duplicate IP addresses on the network. To correct this,
find and change IP address so that all IP addresses are distinct. See