Grass Valley MRC v.1.2 - Manual (Page 118)

108
Router Tools
Crosspoints Page
How to Copy and Paste Crosspoint Data
1 Go to the ‘Crosspoints’ page. From the Control Cards table, at the bottom of the page, select
a control card.
2 Click on the ‘Current’, ‘History’ or ‘Salvo’ tab containing the data you want to copy.
3 Select any number of outputs (i.e., rows). Press Ctrl + C on your keyboard or select Copy from
the context menu.
Or, open an Excel file and copy the Excel data using Excel’s copy command.
4 Select the ‘Current’ or ‘Salvo’ tab into which the data are to be pasted. (You cannot paste into
the ‘History’ tab.)
5 (Optional) Select outputs, contiguous or non-contiguous. The paste result is restricted to the
selected outputs.
6 Press Ctrl + V on your keyboard or select Paste from the context menu. The ‘Paste Cross-
points’ dialog appears:
7 If you are pasting from an Excel file, and the Excel file lists sources in the left column and des-
tinations in the right column, select the Input/Source radio button to rectify the data.
8 Check the Use Selection check box if outputs were selected in step 5 and you want to limit
the paste operation to just those outputs.
For example, if you had selected outputs 1–12 were selected, and the clipboard (and the
Paste Crosspoints dialog) show outputs 10–18, the paste command is applied to the inter-
section, that is, outputs 10–12.