How to perform single takes – Grass Valley MRC v.1.2 User Manual
Page 115
105
Miranda Router Configurator
User’s Guide
This is the ‘Single Takes’ tab:
How to Perform Single Takes
1 Go to the ‘Single Takes’ tab of the ‘Crosspoints’ page. Focus on the ‘Single Take’ section:
2 If you want successive single takes to toggle, check the ‘Toggle After Take’ check box.
3 Specify a level on which the take is to occur in the ‘Level’ drop-down list.
4 Specify an output in the ‘Output/Destination’ field. Specify an input in the ‘Input/Source’
field.
5 Click ‘Perform Take’.
6 The take occurs and is recorded in the Log section. If the ‘Toggle After Take’ check box is
checked, the input field reverts to what it was before the take occurred. Thus, you can toggle
an output between two inputs manually.